Share.

    3 commenti

    1. That is the wrong place. Don’t turn those valves, they are set during installation and if you change them, it might need a company to reset them properly.

      There should be a control device in your apartment to switch on the heating. Usually one or more little boxes on the walls, often with a dial.

    2. That looks like underfloor heating; those valves you see are controlled by a thermostat in each room.

      The thermostats are usually near the doors, and might have a dial with numbers on them. Turn up each thermostat to the temperature you want: room temperature is usually level 4, often marked with a dot.

      The motors inside the valves often break down; your landlord may have to get a heating engineer in to replace faulty valves.

    3. Schuhmeister9 on

      Is it completely new or has been used before? If new, probably some valve is not open enough but I would ask your landlord if they can do that or sent someone to check, as they have a laser to measure the flow and set it correctly.

    Leave A Reply